Do it Yourself Speakers
Speaker Assembly
Step | Instructions |
---|---|
You need:
|
|
Tightly wrap the paper around the wide part of the spindle and tape it. | |
Tape one end of the wire to the middle of the strip of paper so that approximately 3 “ of wire is sticking out. | |
One person holds the wire taut while another winds the wire onto the paper spool. Make sure the wire stays within the middle 1 cm of the paper spool. |
|
Hold the wire with 2 fingers as shown. Do not allow wire to tangle or kink. If this happens, stop and untangle wire. |
|
Continue winding the wire until you reach the end of the 40 feet. Leave approximately 3 inches exposed and tape down wire to prevent unrolling. |
|
Peel the backing off of the double-sided tape. | |
Place a magnet in the middle of the circle on the tape. | |
Press the spool of wire onto the tape surrounding the magnet. Fold the flaps of paper down over the magnet and place another piece of two-sided tape. |
|
Press the cup onto the tape covering the magnet | |
Listen to music with your speaker. |